CHIPCO 26019 FLO BRAND FUNGICIDE

Which of the following fungal diseases is specifically listed as a target for CHIPCO 26019 FLO BRAND FUNGICIDE in turfgrass?

• Alternaria leaf blight
• Dollar Spot ✓
• Cercospora leaf spot
• Powdery Mildew

Answer: The label identifies Dollar Spot as a disease managed in turfgrass, while Alternaria and Cercospora are listed for ornamentals.

🔗 Source

What is the application rate for Cercospora leaf spot on ornamentals?

• 3 to 4 fl. oz. per 1,000 sq. ft.
• 4 fl. oz. per 1,000 sq. ft.
• 1.0 to 2.5 oz. per gallon ✓
• 2.5 oz. per 1,000 sq. ft.

Answer: The label lists the rate for Cercospora leaf spot on ornamentals as 1.0 to 2.5 oz. per gallon.

🔗 Source

If a technician is mixing this product with Cleary's 3339 F, what action must be taken first?

• Increase the rate by 50%
• Check compatibility before mixing ✓
• Only mix in a drip irrigation system
• Apply as a foliar spray instead

Answer: The mixing notes state the product is compatible with certain fungicides like Cleary's 3339 F but to check compatibility before mixing.

🔗 Source

Which PPE is explicitly required for handling CHIPCO 26019 FLO BRAND FUNGICIDE?

• N95 mask only
• Chemical-resistant gloves, protective clothing, and eye/face protection ✓
• Rubber boots and heavy apron
• Safety goggles and earplugs

Answer: The PPE section requires chemical-resistant gloves, protective clothing, and eye/face protection.

🔗 Source

What is the required application method for Alternaria leaf blight on ornamentals?

• Drip irrigation
• General turf spray
• Apply as a drip ✓
• Tank mix only

Answer: For ornamentals like Alternaria leaf blight, the label states to apply as a drip.

🔗 Source

When treating Dollar Spot in turfgrass, what is the recommended application rate?

• 1.0 to 2.5 oz. per gallon
• 4 fl. oz. per 1,000 sq. ft.
• 3 to 4 fl. oz. per 1,000 sq. ft. ✓
• 2 fl. oz. per 1,000 sq. ft.

Answer: The label specifies a rate of 3 to 4 fl. oz. per 1,000 sq. ft. for Dollar Spot.

🔗 Source

What is a restriction regarding the application of this product to water surfaces?

• It can be used as a water treatment if diluted 1:10
• It must only be applied to moving water
• Do not apply to water or near surface water unless specifically directed ✓
• It is safe for all water surfaces

Answer: The restrictions state: 'Do not apply to water or near surface water unless specifically directed.'

🔗 Source

According to the label, what should a technician avoid to prevent drift?

• Applying during windy conditions
• Applying during heavy rain
• Applying near residential zones
• All of the above ✓

Answer: The label instructs to avoid application during windy conditions to prevent drift and to avoid drift into residential zones and water surfaces.

🔗 Source