Grizzly Too

What is the rate for controlling the Armyworm when applying Grizzly Too to Alfalfa?

• 0.015 - 0.025 lb ai/A (0.96 - 1.60 fl oz/A)
• 0.02 - 0.03 lb ai/A (1.28 - 1.92 fl oz/A) ✓
• 0.03 - 0.05 lb ai/A (2.00 - 3.50 fl oz/A)
• 0.01 - 0.02 lb ai/A (0.80 - 1.50 fl oz/A)

Answer: target_pest: ... Armyworm ... rate: 0.02 - 0.03; unit: lb ai/A; notes: 1.28 - 1.92 fl oz/A

🔗 Source

What is the required Re-entry Interval (REI) for Grizzly Too?

• 12 hours
• 24 hours ✓
• 48 hours
• 72 hours

Answer: REI: 24 hours

🔗 Source

Under what condition should an applicator avoid making ground or aerial applications of Grizzly Too?

• During temperature inversions ✓
• When humidity is above 80%
• During periods of high rainfall
• When the target pest density is low

Answer: Do not make aerial or ground applications into temperature inversions.

🔗 Source

Which of the following is a required piece of Personal Protective Equipment (PPE) for Grizzly Too?

• Chemical-resistant gloves (Category G, such as barrier laminate or Viton® ≥ 14 mils) ✓
• Nitrile gloves (Category E)
• Full-face respirator
• Waterproof coveralls

Answer: PPE: Wear long-sleeved shirt and long pants, chemical-resistant gloves (Category G, such as barrier laminate or Viton® ≥ 14 mils), shoes plus socks, and protective eyewear.

🔗 Source

What is the maximum allowable wind velocity for an aerial application of Grizzly Too?

• 10 mph
• 15 mph ✓
• 20 mph
• 25 mph

Answer: Do not apply via aerial application when wind velocity exceeds 15 mph.

🔗 Source

When applying Grizzly Too via aerial methods, what must the applicator adjust for?

• Downwind displacement ✓
• Upwind drift
• Cloud ceiling height
• Soil moisture levels

Answer: When applying via aerial, adjust for downwind displacement.

🔗 Source

When mixing Grizzly Too into a tank, what is the correct sequence and procedure for adding products?

• Add Grizzly Too first, then fill the tank with 1/2 to 2/3 the volume of mixing solution.
• Add Grizzly Too last, once all other products are fully dispersed, after filling the tank with 1/2 to 2/3 volume. ✓
• Add Grizzly Too after filling the tank to full volume to ensure dispersion.
• Add Grizzly Too at any time during the mixing process as long as agitation is continuous.

Answer: Always add Grizzly Too last when tank-mixing. Fill the tank with 1/2 to 2/3 the volume of the mixing solution. Ensure all other products are fully dispersed before adding Grizzly Too. Add the remainder of the mixing solution to reach desired volume.

🔗 Source

According to the label, which application method is restricted for use in chemigation systems connected to public water systems?

• Ground application
• Aerial application
• Chemigation ✓
• All methods

Answer: Do not apply this product through chemigation systems connected to public water systems.

🔗 Source