Vangard WG

What personal protective equipment (PPE) is required for all other applicators and handlers when using this product?

• Filtering facepiece respirator (N95, R95, or P95), waterproof gloves, and long-sleeved shirt
• Long-sleeved shirt, long pants, waterproof gloves, and shoe plus socks ✓
• Goggles, long-sleeved shirt, long pants, and chemical-resistant apron
• Filtering facepiece respirator, long pants, and waterproof gloves

Answer: All other applicators and other handlers must wear: long-sleeved shirt and long pants, waterproof gloves, and shoe plus socks.

🔗 Source

To reduce the potential for runoff, when should applications of Vangard WG be avoided?

• When wind speeds exceed 10 mph
• When temperatures are above 90 degrees
• When rainfall is forecasted to occur within 48 hours ✓
• When humidity is above 80%

Answer: Avoid applications when rainfall is forecasted to occur within 48 hours to reduce runoff potential.

🔗 Source

According to the label, what is the active ingredient concentration and its FRAC group for Vangard WG?

• Cyprodinil (50.0%), FRAC Group 1
• Cyprodinil (75.0%), FRAC Group 9 ✓
• Cyprodinil (75.0%), FRAC Group 4
• Cyprodinil (85.0%), FRAC Group 9

Answer: The active ingredient is Cyprodinil (75.0%), which belongs to FRAC Group 9.

🔗 Source

What specific respiratory protection is required for mixers and loaders performing aerial and groundboom applications?

• A full-face respirator
• An N95, R95, or P95 filtering facepiece respirator ✓
• A chemical vapor cartridge respirator
• A dust mask only

Answer: In addition, mixers and loaders for aerial and groundboom applications must wear a filtering facepiece respirator (N95, R95, or P95).

🔗 Source

Which statement regarding the application of Vangard WG is true based on the label instructions?

• It can be applied as a full spray, in block, alternating spray, or tank-mix programs. ✓
• It can only be applied via groundboom sprayers.
• It must only be applied as a preventative spray.
• It is strictly prohibited for use in nut crops.

Answer: It is a water-dispersible granule designed for foliar applications, which can be applied as a full spray or used in block, alternating spray, or tank-mix programs.

🔗 Source

How should resistance management be handled when using Vangard WG?

• By increasing the application frequency of the same product
• By using only high-dose applications
• By rotating with fungicides from different FRAC groups and integrating it into an IPM strategy ✓
• By mixing it with other FRAC Group 9 fungicides only

Answer: For resistance management, it is recommended to rotate Vangard WG with fungicides from different FRAC groups and integrate it into an overall Integrated Pest Management (IPM) strategy.

🔗 Source

What is the Reentry Interval (REI) for this product?

• 6 hours
• 12 hours ✓
• 24 hours
• 48 hours

Answer: REI: 12

🔗 Source

Which of the following is a stated environmental hazard for Vangard WG?

• It is toxic to bees and beneficial pollinators
• It is toxic to fish and aquatic invertebrates ✓
• It is harmful to soil microbes
• It causes significant groundwater contamination

Answer: It is toxic to fish and aquatic invertebrates; avoid application near water or areas where surface water is present.

🔗 Source